Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Buda, TX
Gate work in Buda sits at the intersection of two very different worlds: fast-built HOA subdivisions with decorative steel driveway gates, and older ranch properties with simple pipe or wood gates that have seen decades of Hill Country weather. Our techs carry parts and know-how for both. The limestone soil, freeze-thaw cycles, and intense UV mean gates here move, sag, and short out in ways you won’t see in flatter, softer-soil towns. If your gate is acting up, call (361) 268-6253 and talk to a live person, any hour.
Why Buda Homes Are Different
Buda’s growth along the I-35 corridor has produced a patchwork of new subdivisions with ornate, oversized driveway gates that must meet strict HOA guidelines, while older ranch properties on the east side still have utilitarian pipe gates. A tech who only knows one style won’t last a week here. The newer gates are heavy, decorative, and often hung on posts set in limestone. The wind off the escarpment is constant enough that sensor brackets creep out of alignment, and we regularly get calls for gates that open fine in the morning and refuse to close by evening.
The housing stock skews 2000s and newer: large homes, long driveways, and gates that are often builder-grade operators bolted onto far heavier gate leaves than the motor was ever rated for. That mismatch is the single most common failure we see in Buda subdivisions. Add hail, flash-flood moisture, and occasional hard freezes, and you get electronics that corrode, wood that warps, and posts that heave. A repair here isn’t just swapping a part; it’s accounting for what the weather and soil have already done to the installation.
Styles & brands we work with





Our Main Buda Services
Most Buda homeowners call us for one of three things: a gate that won’t open or close properly, an electric gate with a dead operator or failed safety sensor, or a gate motor that runs but can’t move the leaf. Each is its own job, with its own diagnosis and its own Buda page.
Gate Repair in Buda
Sagging hinges, dragging gate leaves, bent posts, and misaligned latches are the everyday calls here. In newer subdivisions, the decorative steel gates are heavy and the builder hardware is often undersized. On the east side, older pipe gates suffer from rust, cracked welds, and posts that have shifted in the limestone. We show up with the right tools, a written price, and a repair that’s backed for a full year. Read more on our Gate Repair in Buda page.

Electric Gate Repair in Buda
When the keypad goes dead, the safety sensors refuse to stop the gate, or the opener trips its breaker every time it cycles, Buda homeowners call us for the electrical side of the job. Our techs are factory-trained on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems. We diagnose the exact fault, explain it in plain words, and hand you a written price before any work begins. Details are on our Electric Gate Repair in Buda page.

Gate Motor Repair in Buda
The gate motor is the box that slides or swings your gate automatically. In Buda, the wind and humidity push these motors hard, and the constant cycling of a heavy decorative gate wears out gears and capacitors faster than the manufacturer’s average. We repair and replace motors from all nine brands we service, and we stock the most common parts locally so we don’t have to make you wait on a shipped component. See the full breakdown on our Gate Motor Repair in Buda page.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Buda
We’re authorized service for nine major gate and opener brands, including Ghost Controls, DoorKing, Elite, and Mighty Mule. The most common replacement parts for these systems are stocked in our local trucks, so most Buda repairs are completed in a single visit. See the full list on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Buda, TX
These are the ranges we quote most often in Buda, based on the service calls we run here. Your exact price depends on your gate’s size, hardware, and what we find when we inspect it.
| Service | Typical range in Buda |
|---|---|
| Gate repair (hinges, sag, latch) | $180 – $340 |
| Electric gate diagnostic | $90 – $150 |
| Safety sensor alignment or replacement | $120 – $240 |
| Keypad or receiver replacement | $140 – $280 |
| Opener control board diagnosis | $150 – $300 |
| Gate motor replacement (parts and labor) | $450 – $950 |
| Post realignment or reinforcement | $200 – $450 |
| Full operator replacement | $800 – $1,600 |
| Weld repair on steel or pipe gate | $120 – $280 |
What pushes the price up in Buda? Heavy decorative steel on a builder-grade operator, posts that have shifted in limestone, or a motor that’s been fighting the escarpment wind for years. Whatever we find, you get a written price before any work starts, no surprise line items at the end.
Neighborhoods We Serve in Buda
We serve all of Buda, from the HOA-heavy subdivisions along the I-35 corridor to the ranch roads on the east side. Response time across the area is typically same day for urgent repairs, with next-morning availability for jobs that can wait.
- Sunfield
- Shadow Creek
- Garlic Creek
- White Oak Preserve
- East Buda ranch roads
Service Area – Cities Near Buda
We also cover the surrounding corridor. Our techs run regular routes through San Marcos, TX, Austin, TX, Manor, TX, and Cedar Park, TX. If you’re right on the edge of Buda and one of these towns, call and we’ll sort out which crew is closest.
Serving Buda, TX - Our Local Coverage Area
We’re based in the Buda area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Buda
Most Buda calls are same-day for urgent repairs like a gate stuck open or a motor that won’t respond. Less urgent diagnostics are usually next morning. Call (361) 268-6253 and a live person will give you a window.
If your HOA requires approval for gate changes, that’s on you to obtain before we start. Repairs that restore the gate to its existing condition, like fixing a hinge or replacing a sensor, generally don’t trigger HOA review. We won’t change the gate’s look or hardware style without you asking.
Yes. Older pipe gates and wooden ranch gates are a big part of our work on the east side of Buda. We weld, reinforce, and rehang them, and we can add automation to a simple gate if you want it. Call (361) 268-6253 for a free estimate on any of it.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Buda Customers Say
"Rusty chain drive got cleaned, lubed, and re-tensioned. He told me what to do each year to keep it going."
- Leon M."Remotes were out of range. He replaced the antenna and re-paired the remotes. Works from the street now."
- Valerie T."Fair price and no pushing a whole new gate when all I needed was a new motor capacitor."
- Shirley A.